I remember reading somewhere on this site or in "Mainsheet" that this association has a prop puller to loan. Is it still available?
"Seawing"
haul# 309 2005
Prop puller "loaner"
Moderator: KenKrawford
-
- Posts: 614
- Joined: Wed Nov 02, 2005 8:54 pm
- Location: Atlanta, GA
Re: Prop puller "loaner"
Currently the Catalina 350 IA does not have a tool loan program set up although it was briefly discussed at the last bridge meeting. As far as I'm aware the Catalina 36 IA is the only association with a tool loan propram. I did contact them to get some feedback on the level of interest their members had. The person I spoke with indicated that it was seldom used and primarily for the cutlass bearing removal tool.
Ken Krawford
Message Board Moderator
C350 # 351
Lake Lanier, GA
Message Board Moderator
C350 # 351
Lake Lanier, GA
Re: Prop puller "loaner"
Hey Ken,
I need to install a new cutlass bearing. I am in the process of collecting tools/parts etc. My prop has been on the shaft for 13 years, the threads are very salted up. I have been soaking the nut with penetrating oil.
The puller is the next step.
Erik
"Seawing" #309 2005
I need to install a new cutlass bearing. I am in the process of collecting tools/parts etc. My prop has been on the shaft for 13 years, the threads are very salted up. I have been soaking the nut with penetrating oil.
The puller is the next step.
Erik
"Seawing" #309 2005