Catalina 350 International Association

I spoke with Frank Butler and Jerry Douglas 2 weeks ago about this same problem. They told me that it is an inconsistent problem. Some people's seem to be fine and others are having problems. I put an hour meter on my compressor and found that it ran 70% of the time in the summer (Atlanta, GA) and 3...

Sam,
Thanks very much for the reply. Roughly how far up from the bottom edge of the muffler did you drill?
I think a safety wire is a great idea.

It seems that every time I check my batteries, there are varying amounts of electrolyte that have leaked from the caps. I don't think I have overfilled the cells.
Anyone else experiencing this?

Included with my antisiphon kit from Catalina was a thumb screw and washer/gasket to install on the muffler. There is also a wooden "cradle" that elevates the front of the muffler. The instructions state to drill a hole on the front of the muffler with a # 7 drill bit. The hole is then tap...

Tim,
There were several cans of factory gelcoat that came with my 350 delivered in April 2005. Of course the dealer used them to fix some problem areas and I've not seen them since.

(Note to self: Call dealer and tell him I want my gelcoat back!)

No, my boat stays in the water all year.

Tom, I have the same problem, although to a lesser degree than you. I'm not sure but suspect it may be around the inspection port cover in the front of the anchor locker. You could remove the access panel for the windlass in the front of the V berth and peek around there to see if water is getting i...

My boat/engine are only 7 months old and I have added coolant twice to the reservoir. Each time the level was about 1/2 " below the ADD line. There is no evidence of a coolant leak around the engine and the temperature stays at 170. Do I have a problem or should I just forget it and leave it as...

Tim, I've struggled with the same problem. I've seen some people put on adhesive backed plastic pieces that they cut from weather stripping. Personally, I don't like the way they look on the boat but they do seem to work. The best product I've found to remove the streaks is Meguiars Cleaner Wax. I u...

I'm able to keep my boat in the water and use it year round but sometimes the temperatures fall below freezing.

Has anyone figured out a way to keep the hot water heater operational yet protect it and the hoses from freezing?

Dave, I share your frustration about the refrigeration on the C350. I took delivery of my boat in April of this year and the first thing I noticed is that the compressor would run constantly. An Adler-Barbour authorized tech looked at my unit, replaced the evaporator and tweaked the freon levels. I ...

I think others will back me up on this - it appears that moisture inside the instruments on the pedestal has been a frequent problem on the C350. Mine was more noticeable when I first took delivery that it has been recently. I don't think it causes any long term problems. The moisture will evaporate...

Jerry,

This format looks terrific. I know many people prefer an email format but I always found reading email replies in a message board format very difficult.
Thanks for getting this started.