Search found 6 matches
- Sun Mar 17, 2024 10:10 am
- Forum: Hull, Prop, and Rudder Forum
- Topic: Hunting VC-17 Facts or Fiction Bottom Paint
- Replies: 11
- Views: 205
Re: Hunting VC-17 Facts or Fiction Bottom Paint
Yes thats right Teri. One gallon painting from waterline right down under the keel. Preparation was just a light sanding of the old vc17 and then pressure wash off the dust. Once dry roll on the Pettit. One gallon easily covered everything below the waterline. Scott it is the Pettit HRT ECO Copper F...
- Mon Mar 11, 2024 10:31 am
- Forum: Hull, Prop, and Rudder Forum
- Topic: Hunting VC-17 Facts or Fiction Bottom Paint
- Replies: 11
- Views: 205
Re: Hunting VC-17 Facts or Fiction Bottom Paint
Hi Guys We’ve had vc17 on our hull for about ten years as thats what most racer types swear by around here. It always bothered me as it was such a dirty substance given the fact its made to wear off into our lake water. A couple years ago i started looking for a better option. I found Pettit HRT Eco...
- Tue May 19, 2015 3:24 pm
- Forum: Rigging Forum
- Topic: shrouds
- Replies: 2
- Views: 3979
Re: shrouds
Thank you very much for your reply. We have it the other way, but will leave it for this season.
Tom
C350 #237
Tom
C350 #237
- Mon May 18, 2015 4:22 pm
- Forum: Rigging Forum
- Topic: shrouds
- Replies: 2
- Views: 3979
shrouds
Howdy
Folks I'm prepping my mast to be stepped tomorrow, for my first time. I'm trying to figure out where to run the masthead shroud through the spreader ends...forward holes or aft holes? My mast is a seldon for a Cat 350 with in mast furling.
Tom
Folks I'm prepping my mast to be stepped tomorrow, for my first time. I'm trying to figure out where to run the masthead shroud through the spreader ends...forward holes or aft holes? My mast is a seldon for a Cat 350 with in mast furling.
Tom
- Sun Aug 17, 2014 7:10 am
- Forum: Plumbing Forum
- Topic: Clogged strainer
- Replies: 3
- Views: 6510
Re: Clogged strainer
Hi Guys
Yes I'm talking about the strainer/filter attached to the pump under the galley sink.
Motoring has been limited so far but I'll pay closer attention to the heat guage.
Cheers
Tom and Pam
Dream Chaser
#237
Yes I'm talking about the strainer/filter attached to the pump under the galley sink.
Motoring has been limited so far but I'll pay closer attention to the heat guage.
Cheers
Tom and Pam
Dream Chaser
#237
- Fri Aug 15, 2014 7:50 am
- Forum: Plumbing Forum
- Topic: Clogged strainer
- Replies: 3
- Views: 6510
Clogged strainer
Good Morning Folks We're new into keelboats and bought #237 in the spring. We've had a great season so far and learning every time out. The previous owner had the pink antifreeze through the system so we rinsed it a few times to clear it. Recently it's had a flow/preasure problem so we started inves...